Q: I am making a replacement cable for my Line 6 wireless unit - How should I wire the cable?

A: Here is the wiring from the 1/8" TRS jack to the 1/4" mono plug: Tip and Sleeve from the 1/8" jack go to the 1/4" Sleeve (ground), the Ring on the 1/8" TRS jack goes to the Tip (Hot) of the 1/4" jack.

Q: I’m not sure if the plastic casing can hold up to the abuse I put my XDS95 through

A: The units are made of polycarbonate, are very sturdy and and backed with a two-year warranty. Polycarbonate is the same material that bullet-proof glass is made from. We have tested the receiver casing with over 300lbs being applied in a stomp test and it handles the pressure without breaking a sweat. Therefore, we will not be making a metal version of this unit.

Q: Is there any way to make an external antenna for the XDS95 or is it even necessary?

A: The antennae are built into the chassis of the XDS95 and perform quite well. Therefore there is no need for external antennae.

Q: The belt clip seems to easily fall off my strap with the slightest jumping around. How can I avoid this?

A: Thin straps are typically the culprit. Weaving your guitar strap through the clip will help to ensure a secure fit.

Q: I would like to buy multiple transmitters. Where can I find them?

A: Please see a list of our dealers on our authorized dealers page. Any of our dealers can order additional available accessories if they are out of stock.

Q: Do you offer replacement and or extra cables? Do you also offer an angled plugged cable?

A: The cable that comes with the unit is a straight plug. We do offer replacement cables with both straight and right-angle plugs.