Can't edit the first post so here. thanks

I checked the line 6 power supply faq that there's an alternative to a  [9VAC 1200mA minimum] power supply.

it said
"PX-2 AC: (Stomp modelers, All PODs, XT, and X3 series, XPS, Micro Spider): Output: 9v AC, 2000mA. The center pin diameter is 2.5mm.
*
Line 6 power supplies are available at you local dealer or at our Online Store.
*
Note: The Stomp Box Modelers will also work under DC (Direct Current) at 12V, 500 mA minimum. The center pin is positive (yes, center pin is positive as opposed to the DC-1 power supply)."

--

but then i checked the flatliner site and it said

"The Line 6 modelling pedals can be powered through the 9VDC (MM4, FM4) or 12VDC (DM4,DL4) outputs. Since these effects draw more current (150-185 mA) than average you can connect one effect with one output. The FLATLINER can power several Line 6 effects simultanously. Note: Line 6 modelling effects have reversed polarity. Use the right cable."


9VDC and 12VDC?

help? what does it really run in? I really should be believing the line 6 site, but i asked the line 6 dealers here and they said that i can't use a 12vdc adapter. can i please have a confirmation that it really CAN run on 12vdc 500mA? I'm using a DL4 and an MM4.

Plus, does it have to be regulated?

and if ever its allowed, i was wondering if i could use a 1000mA 12vdc adapter to chain a dl4 and an mm4.

sorry if im asking too much. I hope you guys answer this

thanks

Lester