Re: Using Lowdown 400 head with LD300

support@line6.com — Fri, 18 May 2012 00:38:19 GMT

Get the LowDown 300's DI output circuit diagnosed and serviced would be the best option if you like the amp. It's probably not too complicated a fix, but have an Authorized Service Center tech dig in and verify the root cause and what the solution is (probably replacing a component/part): http://line6.com/service_centers/

Otherwise, you could mic the speaker signal on the combo amp since it's outputting audio just fine...

Using Lowdown 400 head with LD300

support@line6.com — Wed, 04 Apr 2012 23:41:31 GMT

So I'm having an issue with the direct out on my LD 300 combo, but otherwise the amp works perfectly. I need the direct out to feed our PA. I could use a direct box, but then I would loose my "tone.". I was thinking of getting the Lowdown 400 head and running that into the 300. Obviously the easiest way to do it is to use the 400 as a pre-amp. If I do this, what is the best flat setting for the 300?

Another option is to bypass the 300 amp entirely and rune it directly to the speaker, since it is an 8 ohm speaker, this should work. I will, however, need to do some rewiring to make this work. Is this a good/bad idea?

I'm open to any suggestions. I love line 6 and want to make this work. Thanks.

Community: Message List - Using Lowdown 400 head with LD300

Re: Using Lowdown 400 head with LD300

Using Lowdown 400 head with LD300