Q: Where do I get a Relay G30 Series Wireless System for use in the US?
A: The Relay G30 is available at all authorized Line 6 dealers. To locate a dealer near you, please see our Dealer Finder.
Q: Where can I purchase replacement Relay G30 transmitters (TBP06) or receivers (RXS06)?
A: You can order them from any authorized dealer.
Q: What are the specs on the provided Relay G30 Series power supply (DC-1G)?
A: 9.6V DC, 500mA, pin center negative. See the following link for more power supply FAQs:
Power Supply and Amp Power F.A.Q.
Q: Can I use a Voodoo Lab Pedal Power Plus 2 to power the Relay G30 receiver?
A: Yes, but you will need to use the Voodoo lab "doubler" cable and you will need to use any two outputs of the Pedal Power Plus set to the "normal" position. See the following link for more information on the "doubler" cable available from Voodoo Lab:
Voodoo Lab cables
Q: What type of cable do I need between my guitar & Relay G30 (TBP06) transmitter?
A: Any mono (tip-sleeve) instrument cable will work for both the instrument to the transmitter and the receiver output. We do not recommend using TRS ("stereo") instrument cables.
Q: If you leave the transmitter cable plugged but turn the power off on the transmitter, does the cable still use up battery life even if the transmitter is powered off? Similar to some analog stomp boxes?
A: When the power is switched off, the audio input has no bearing on battery draw, cable in or out.
Q: Is the Relay G30 (TBP06) transmitter compatible with the X2 receiver (or vice versa)?
A: Both systems run in completely different frequency ranges so they are not compatible with each other, but X2 and Relay units can be used on the same stage (along with any other analog wireless systems) with no problems.
Q: I'm a harmonica player and would like to use the G30 with a bullet microphone (high impedance and high output). Its output peaks at approximately 3V to 4V. Will there be clipping or distortion of the output?
A: No problem with either impedance or input level. The Relay transmitters (TBP06 and TBP12) will handle 6V inputs.
Q: What is the output impedance of the RXS06 Receiver ?
A: The output impedance of the RXS06 Receiver is 200 ohms.
Q: How do I register my Relay G30 System?
A: You can register on your account:
Red: Low battery
Purple: On channel change
Green: Signal at input
Orange: On power / channel change.
Green: Signal at receiver input
Top: Signal Strength
Bot: Tx Battery Life