Skip navigation
Line 6 - Support
Up to Discussions in Line 6 Lounge
1024 Views 2 Replies Latest reply: Feb 14, 2010 8:53 AM by myst3rymus1c RSS
fenderchris2 Just Startin'
fenderchris2
23 posts since
Sep 6, 2009
Currently Being Moderated

Dec 30, 2009 1:11 PM

Is there some software I can use to setup the POD X3-PRO?

I understand that there is a version of POD Farm that can be used to control my POD X3-PRO.

 

Where can I get it from?

 

A search of the Line6 site provides nothing?

 

I've heard about the POD Farm Platignum plugin that can be run with an iLok key, but I believe there is also a version that would be tied to my X3-Pro.

 

Could someone from Line6 please provide an answer to this question in the near future?

  • fenderchris2 Just Startin'
    fenderchris2
    23 posts since
    Sep 6, 2009
    Currently Being Moderated
    Jan 20, 2010 7:45 AM (in response to fenderchris2)
    Re: Is there some software I can use to setup the POD X3-PRO?

    Replying to my own question: Apparently not! - The Pod Farm software supplied with the X3-PRO is a plugin that can not actually control the X3-PRO. It just uses the X3-PRO as a key when running the plugin.

     

    Slightly confusing (mis-leading) marketing I would say.

     

    In any event, I've now sold the X3-PRO and am using the POD Farm Platignum plugin on its own.  It's pretty good.

    • myst3rymus1c Just Startin'
      myst3rymus1c
      2 posts since
      Apr 2, 2009
      Currently Being Moderated
      Feb 14, 2010 8:53 AM (in response to fenderchris2)
      Re: Is there some software I can use to setup the POD X3-PRO?

      I use gearbox, it will let you setup patches for the POD X3 pro and load them on and off, also you can download patches and transfer them using this software. You should be able to download it for free using the Line6 Monkey software just make sure your x3 is attached to your PC via usb... It is confusing though - basically you get Gearbox as a standalone editor for your X3 hardware and you get Pod-Farm as a plugin for your DAW (protools, logic cubase etc) which as far as I can tell just uses the podx3 as an expensive dongle...

More Like This

  • Retrieving data ...

Bookmarked By (0)