Hi Silverhead,

Thanks, but yeah they are from the X3 section.

I have loaded XT ones in the past with out any issues when using an PodXT, Pod XTLive and then the PodX3 Live and just tried again and get exactly the same error.

but this error is only since I have been trying now I am officially supported, not been able to do anything like this for over six months.

I also tried the Lincon Brewster X3 bundle an get "Unable to Load file", though on his site it says you do it with monkey...so not sure if you should be able to open this l6t into gearbox.

Cheers

BMF

I tried to open the files in PodFarm (on Windows 7) in offline mode and they open fine.

But obviously I can load them onto the Pod X3

HI Andy,

The issue seems to be when you open any l6t file OFFLINE in GearBox, ie you do not have anyhting connected.

I can open files in PodFarm offline and it works as expected.

I can open the files in GearBox if I plug in the PodX3 Live so in ONLINE mode it works fine.

Interestingly I just tried it in OFFLINE mode, but specified the OFFLINE mode to work as if a KB37 was connected and it worked fine, then I tried again in OFFLINE with PODX3 Live selected (not connected though) and I get the error.

OK!!.. Just done some more testing and I get the following results.

If you open the same l6t file in OFFLINE mode and select the following hardware you get the following:-

Any Pod X3 based product - you get the error above

Any Pod XT Based Product - you get an error about the selected interface is not available, but the tone loads as you would expect and you can see the settings

Any TonePort Based Product - Works as you would expect

So it seems to be an issue with the PodX3 side of things only.

Hope that helps.

Cheers

BMF