http://www.homedepot.com/h_d1/N-5yc1vZ1xj8/R-100150034/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053

I like those

toelessfoot wrote:

 

One question though: Since I now have 3 cables going out the m13 to the back of the JVM, are there any tricks for wrapping the cables together to make setup easier? Or could I just duct tape them together?

I use small, black zip ties.  Available at any hardware store.  Then I use electrical marking tape in various colors to color code the cable ends, and the inputs on the amp and the M13.  Setup so easy, a roadie can do it for you.

Hi Toelessfoot, I read your post and was wondering if you could please explain to me in detail if you have time how you married your jvm head and your m13.I am not able to change the channels on my head with the midii commands from the m13. I have the same setup as you and can't marry the 2. Here is what i have done so far.

I am in latchmode mnl on a different scene than the one i want to save

i reset my jvm head and the the channel i want to select with each scene

midi channel on m13 is at 1 and i have tried omni

i get the jvm head in midi mode with the blinking light and then hit the m13 scene i want to save

the blinky light on jvm head still blinking and when i check it the amp channels are not saved

my cables are hooked up in 4cm and the midi cable is going from m13 out to jvm head midi in

Can you please advise me on what i am doing wrong? Please?

Jane

Could one of you all using the M13 and the Marshall JVM help me out? Please? I have exhausted all possibilities.