Currently Being ModeratedOct 27, 2010 12:59 PM (in response to sbartlett85)RE: Very weak signal from condenser mic to UX2
Here are a couple of things to check. In the POD Farm software, click on the Mixer button and you will find a +18 dB button next to the Record Send 1-2 and 3-4 sliders. This button will boost the output from the POD Farm software into your recording program. Use the red slider to minimize the amount of boost if it is too much.
Also, go into the Mac's Audio-MIDI Setup in Applications/Utilities. Select the UX2 device, and ensure that the Input and Output levels are all the way up (or as high as you need them.)
Currently Being ModeratedOct 27, 2010 6:43 PM (in response to Line6Hugo)Re: RE: Very weak signal from condenser mic to UX2
Thanks for the reply, Line6Hugo,
Everything is cranked in the POD Farm software (+18 dB buttons pushed and both sliders all the way up). Looking into the Audio-Midi Setup utility though, it appears the Master volume for both input and output from the UX2 is set very low. But the slider associated with it is grayed out and I can't adjust it. Each individual channel is set high but it doesn't seem to affect the master at all.
Currently Being ModeratedOct 27, 2010 7:49 PM (in response to Line6Hugo)Re: RE: Very weak signal from condenser mic to UX2
As an added note, I did try hooking up a preamp to provide the mic with phantom power and that seemed to give me the juice I needed. Is it possible there's something wrong with the phantom power source on the UX2?
Currently Being ModeratedOct 28, 2010 9:13 AM (in response to sbartlett85)RE: Very weak signal from condenser mic to UX2
Not sure what the problem could be here so far and cannot speculate if there is a hardware problem with the UX2 at this point yet.
Can you provide a screen shot of how your Audio-MIDI setup page looks?