No, there is no 'click', like TheRealZap said, it takes some force - even standing up! You can calibrate the Shortboard without being connected to the computer. FBV Shortboard MkII Calibration Steps
• Start with your FBV device not connected to any USB port or Line 6 device (and, therefore, powered "off"). • Press and hold down the "D" labeled footswitch while you "power on" your FBV (by connecting to your computer’s USB port or Line 6 device with which you plan on using your FBV). The LCD will read "CALIBRATE PEDAL" until the D footswitch is released, at which point it will read "1 PEDAL TOE".
• Press the on-board pedal forward fully and hold down pedal’s Toe Switch until the LCD changes to "2 PEDAL MIN". This should occur instantly.
• Move the pedal to the "heel" (minimum) position. While holding the pedal in the heel position, press & release the D button. The LCD will change to "3 PEDAL MAX".
• Move the pedal to the toe (maximum) position,
without
clicking the Toe Switch. Allow the pedal to rest in the toe position and press & release the D button. The LCD will change to "CHECK VALUE 127". • Move the internal pedal and verify that the LCD reads "CHECK VALUE 0" in the minimum position and "CHECK VALUE 127" in the maximum position.
• If you happen to get different values than "0" or "127", then try repeating these calibration steps. If your values are correct, then calibration was successful - power off your FBV and power it back on and you are ready to go!
Standard USB cable for connecting (rectangle one end, square connector on the other) - Line 6 does not provide one with the pedals, for some reason.
Line 6 Story
News
Press
Jobs
Support
Contact Us
