Skip navigation
Up to Discussions in Line 6 Lounge
332 Views 7 Replies Latest reply: Jul 4, 2012 12:22 PM by King_Balfour RSS
King_Balfour Just Startin'
King_Balfour
5 posts since
Jul 4, 2012
Currently Being Moderated

Jul 4, 2012 7:24 AM

Line 6 POD HD400 not working help

Right I have had my POD HD400 for a few weeks now and everything has been great, i get a computer so get the full use of it and activate warranty and it all works fine. So I have updated everything on the line 6 monkey program and disconnect it from the pc to use it more. I plugged it into my amp again, and nothing. no sound or signal. Take out the leads, they both work fine, double check the ports I insert them into and still nothing. The small screen is working fine, it shows the bank selection and everything else but the pedal board is just not working, can anyone help?

  • spaceatl Expert Line 6 User
    spaceatl
    4,456 posts since
    Jan 24, 2007
    Currently Being Moderated
    Jul 4, 2012 7:34 AM (in response to King_Balfour)
    Re: Line 6 POD HD400 not working help

    I think so...There is a peculiar thing about the HD400 and the USB controller. Your PC will actually detect it when the power is removed from the HD400...I have an HD400 and this has happened to me a couple of times...Basically, this usually means that you powered down the HD400 while the USB was still attached to the PC...I think what happens is that the HD400 switches to a partial PC mode where the USB level is at zero and it affects all outputs...For some reason, the condition does not clear on power up...Just my own running theory...

     

    To get it back, power up the HD400, connect USB and fire up Edit or Monkey to make sure the connection is fully up...shut down Edit or Monkey and disconnect USB from the HD400 while the HD400 is powered up....just remember to always detach USB while the HD400 is on...

     

    Please let us know how it goes...

  • King_Balfour Just Startin'
    King_Balfour
    5 posts since
    Jul 4, 2012
    Currently Being Moderated
    Jul 4, 2012 11:33 AM (in response to King_Balfour)
    Re: Line 6 POD HD400 not working help

    Ok so I have managed to make it work as long as wah is activeated can anyone tell me whats going on?

More Like This

  • Retrieving data ...

Bookmarked By (0)