Currently Being ModeratedJul 14, 2012 1:59 PM (in response to jimsreynolds)Re: 4CM With HD Pro + GSP1101
Yeah, you can do it. If you really wanted to go nuts you could run a 4CM inside your 4CM (in principle at least ).
The hookup would go
- Guitar -> Pod input
- Pod FX Send --> GSP Input
- GSP FX Send --> Amp input
- Amp FX Send --> GSP FX return
- GSP Output --> Pod FX Return
- Pod Output --> Amp FX Return
By doing this, the setup will give you
Guitar --> POD FX --> GSP FX --> Real Preamp --> GSP FX --> POD FX --> Real Power Amplifier
You could change it around and have the GSP FX wrapping the Pod FX or even some crazy hybrid by messing with the cabling order some more.
I think though that you might just drive yourself nuts if you try and get too clever with all this. What do you want from the GSP?
Currently Being ModeratedJul 14, 2012 2:36 PM (in response to V_Fluffy)Re: 4CM With HD Pro + GSP1101
Well in the 'classic' order of effects: the compressor would go before the amp and the other effects after. Therefore. if you want to use all of those effects then the 4CM inside 4CM message I suggested above may actually be the way to go .
GSP1101 manual is here --> http://www.digitech.com/system/documents/2/original/GSP1101Manual18_0474_B.pdf?1286481757It seems that the effects order is fixed, unlike the POD but that everything is in the classic order. You would cable up as I suggested above and set everything to run at -10dBV (instrument level). The GSP would need a global setup to work with an 'External Preamp' as per page 51 of the printed manual. The Pod setup would be as per the 'first method' here --> http://line6.com/support/docs/DOC-2522 . I cannot really give you the detailed setup for the GSP as I have not used one but try and keep unity levels Throughout
If the layered 4CM thing is just too much then I would simply put the GSP1101 between the POD 1/4" Out and the Amp FX Return. This gives you all the effects after the POD. i.e
- Guitar -> Pod input
- Pod FX Send --> Amp input
- Amp FX Send --> Pod FX Return
- Pod Output --> GSP Input
- GSP Output --> Amp FX Return
You could also hookup the HD500 Midi Out to the GSP Midi In and keep the patches in sync.
Currently Being ModeratedJul 18, 2012 3:39 AM (in response to V_Fluffy)Re: 4CM With HD Pro + GSP1101
You need to be more specific. What FX Blocks? Where?
- If you are asking aboutthere the FX Loop block for 4CM then check the 4CM guide I referenced previously.
- If you are asking about where FX blocks should go in terms of their sequence then try the order mentioned in this doc --> http://line6.com/support/docs/DOC-2523