Hi guys, hope you can help.

I've seen sort of similar to what I need on this discussion, http://line6.com/support/thread/86707 , but am not fully grasping whether I'd be able to use the m9 to change the channels on my SwitchBlade at the same time as changing effects? Would I be able to go to specific channel "banks" and "patches" in the banks on my amp and assign, say, Harmoniser, delay and flanger? I'd be going straight in the front end of the amp.

So it'd look a little like this:

Bank1:

Patch A: Clean(amp), Compressor, Chorus

Patch B: Dirt(amp), Reverb, delay, harmoniser

Patch C: Dirt(amp), Delay, Octave

Patch D: Dirt Lead(amp) Delay, Phaser, Harmoniser

Bank2:

Patch A: Clean(amp), Compressor, Reverse Delay

Patch B: Dirt(amp), Reverb, delay, Flanger

Patch C: Dirt(amp), Delay, Whammy

Patch D: Dirt Lead(amp) Delay, Phaser, Harmoniser

Sorry if the questions have been asked and answered. I can't find them and I'm also not too bright when it comes to midi.

I know I've used my X3 Live to do this before but it was a little tone sucky so I stopped using it. I thought I'd ask for the benefit of the Line6 community knowledge before I purchase the unit

Best wishes and thanks in advance for any help,

Mick