Good day all. After spending 2 days reading most of the post on here I see that this seems to be a rather common problem.  I tried to update my "new to me" Vetta II combo last night.  I have a Tascam us-122 that I was going to use as my Midi interface.  I have no problems with it when I connect to my Vetta and use my Midi program.  I can send Midi dumps to it without a problem.  I can send Midi files from the program to my Vetta with no problem.  I can even use the Monkey to recognize the Vetta with it.  However, when I try to open Line 6 Edit....it shows the Vetta, but will not load anything due to "Communucation Error".  I also tried to update to 2.5 firmware, but when I get to the first step where I am suppose to turn it off, then back on holding down COMP I get nothing on the screen.  So being the genius person that I am, I hit TAP to cancel and the amp goes back to normal operation.  I was going to go get the M-Audio UNO today at GC when they open, but I want to find out that if I get the same screen issue with it....should I just hit EDIT to keep going with the update or hit TAP and just call it a wash?  Any help out there would be great.  I suppose I will try the Line 6 Edit program first to see if I can get it to show up properly with all my patches in it, but if that doesn't work either....is there any remedy out there?