Currently Being ModeratedNov 19, 2012 12:34 PM (in response to bruce1955)Re: HD500 DT50 & JOHN TYLER VARIAX
Bruce - Welcome to the world of Line 6. I'm no expert, but I have been using Edit since my Spider Valve order 4 yrs ago.
What I would do is this...for volume, what I do is go into the Controllers section, select your amp in the Model area, then FS Assign to "Exp Toe Switch", then for Parameter, select "Ch Vol", then Controller to Exp-1, finally, set the range - I usually go 0-100% (low/high) so that I can go from silence to full volume. Then its just a matter of using also your master volume on your amp when at full volume.
If that's not enough volume for you, then you can use in Mixer the leftmost slider and go up however many DB you want it boosted. Or you can add a EQ and just turn on the boost part of it.
Hope that helps.
Currently Being ModeratedNov 19, 2012 4:25 PM (in response to bruce1955)Re: HD500 DT50 & JOHN TYLER VARIAX
Have you used the L6 link technology? I personally do not own the DT-50, but I have demo'd one several times with my own guitar and my own POD, and that worked just fine....the tones were good.