Skip navigation
Up to Discussions in StageScape M20d Mixer Community Support
80 Views 2 Replies Latest reply: Nov 29, 2012 10:54 PM by dboomer RSS
fred7sides Just Startin'
fred7sides
16 posts since
Aug 10, 2012
Currently Being Moderated

Nov 24, 2012 2:34 AM

problem with a monitor output icon : always light on

hi !

 

yesterday i've switched on my m20d and bad surprise ! even with no cables plugged, the icon of the "A" monitor is light on, as if a cable was plugged into it, but there is no cable physically plugged in !

 

i've tried to plug a cable with a powered monitor and made a test, it works, i have sound and no buzz, no problems... when i move the cable, monitor icon always light on

 

if i launched another old scene setup or create a new one, same problem, "A" monitor icon is always light on

 

what is the solution ? reset factory ? hard reset ?

 

if i want to backup my setup scene on usb drive, did i have the risk to stored too the monitor light on problem ?

 

did someone have the same problem ?

 

thank you

 

Fred

  • line6jonb Line 6 Support
    line6jonb
    47 posts since
    Jun 11, 2012
    Currently Being Moderated
    Nov 29, 2012 6:10 PM (in response to fred7sides)
    Re: problem with a monitor output icon : always light on

    Hello,

     

    I am confused by exactly which monitor light you are referring to.  Many times when a light is brighter than others that means it is currently selected, and is not necessarily affected by if something is connected to that input.  If you want to perform a factory reset, you can do that from the i menu< show system settings.

     

    Be aware that setups and scenes are different.  Scenes are part of setups.  Your stage layout and channel levels/settings will be saved in our scenes, but trim (input) levels are saved as part of your setup. 

     

    Jon

  • dboomer Line 6 Support
    dboomer
    1,997 posts since
    Oct 13, 2008
    Currently Being Moderated
    Nov 29, 2012 10:54 PM (in response to fred7sides)
    Re: problem with a monitor output icon : always light on

    Hi Fred

     

    Are you seeing a green light in the patchbay?  Try plugging and unplugging a cable in that jack a few times.  There is a little switch that does the auto sensing that may be stuck.  Give it a little wiggle.

More Like This

  • Retrieving data ...

Bookmarked By (0)