New Line 6 owner and new to the group. I just got an X3 Live and can not figure out how to use T1 - T2 in one patch... Let me explain------Right now, I have 1-4 set up as: 1) acoustic. 2) clean. 3 ) overdrive with a little delay. 4 ) lead with delay and chorus.
Now, if I were in patch 1 ( acoustic TONE 1 ) but wanted a different acoustic sound with a little wetness. How do I program TONE 2 (patch 1) like that instead of toe tapping to Bank 2 Patch 1 ( TONE 1)?
I use to own a GT -8 with a crap load of external stuff BUT I mainly used my FS-6 inconjunction with the GT 8 on one patch, so that 1 patch had 3 different sounds ( wet, dirty, echo cho ho ) -- you get the point?
You would set patch 1 to be a single (not dual) Tone patch, and use the Tone footswitch to toggle between the two Tones in patch 1. To change the mode, hold down the Tone switch for a couple of seconds. In Dual Tone mode you will see both Tones in the display. In Single Tone mode you will see only one Tone, and the one you see (the active tone) will toggle with the switch.