Currently Being ModeratedJan 27, 2013 3:47 PM (in response to chrislanie)Re: Pod xt pro: output knob at zero but still hearing volume???
Have you tried reflashing the firmware?
Do you have a footpedal attached? This may need calibrating if so.
I'm not sure if this pot is governed by the firmware - it may just be a volume pot at the end of the chain, which would mean it's a hardware issue.
Currently Being ModeratedJan 28, 2013 11:47 AM (in response to chrislanie)Re: Pod xt pro: output knob at zero but still hearing volume???
Thanks for the reply.
No footpedal attatched so rules that one out.
I did consider reflashing but wasn't sure if that would reset to factory settings and affect my metalshop pack? Would the 'safe reflash' be better?
Currently Being ModeratedJan 28, 2013 3:20 PM (in response to chrislanie)Re: Pod xt pro: output knob at zero but still hearing volume???
You should always back up your patches before any procedure. Use the GearBox software for this. You should get a dialogue before reflashing to back up your patches anyway, but it's always good to have your own tried and tested back-up.
As long as the Metal Shop expansion is tied to your account then you even if a reflash made it disappear you could reactivate it from Monkey logged into you account. However be warned that if you bought the Pod second hand and the owner did not sign over ('gift' in Line 6 speak) the Metal Shop to your account it will be disabled as the licence manager will think he owns the Metal Shop and not you.