Currently Being ModeratedJul 27, 2010 11:22 AM (in response to Meteoroz)RE: UX1 without Pod Studio
Your first issue is actually a known issue that will occur if you put your system to sleep with the UX1 connected, then start it back up again. Make sure to disconnect the hardware before putting your system to sleep mode as any problems that occur from sleep mode are unsupported.
As for your other problem, you should be able to get system audio from the UX1 when it is set as your default playback device in the Sounds utility in Control Panel.
Make sure to test all of your computer's USB ports and to remove all other devices (especially USB hubs, even if not in use) while troubleshooting this issue.
There is a possibility that it could be our drivers not working properly on your system as we have announced that there are problems with our drivers on some Windows 7 configured computers. This has been made as an announcement at the following link titled 'Support Bulletin For Drivers':