Currently Being ModeratedMay 2, 2011 9:09 PM (in response to jackalope123)Re: HD400 Wah/Vol pedal problem!!!
Just covering the basics here. Have you updated the firmware to the latested version? Should be at 1.20. After the firmware update did you perform a factory reset? Once you have done these two you then calibrate the pedal.
Factory reset video
Calibrate the pedal video
Make sure you have done these and in the order listed.
I hope this helps. Good luck!
Currently Being ModeratedMay 4, 2011 9:54 AM (in response to jackalope123)Re: HD400 Wah/Vol pedal problem!!!
Again, just covering the obvious but easy to overlook......
The pedal range is editable within each preset. Are you sure this is a general problem rather than normal behaviour within one or more presets you happoen to be using? Check your edit settings for the min/max range of the pedal. Make sure the specified range is the full 0% to 100%; otherwise, your pedal may simply be behaving within the range your preset is telling it to behave.
EDIT: Sorry - I just re-read your question again and I believe you specified that you have already checked this out. Still may be worth another look.
Currently Being ModeratedFeb 5, 2012 7:29 AM (in response to jackalope123)Re: HD400 Wah/Vol pedal problem!!!
Just to add a comment:
I was having the very same problems with the Wah. Then, I performed the factory reset and the calibration and everything is ok now.
Great piece of equipment.