357mag Posted February 9, 2015 Share Posted February 9, 2015 I picked up a used POD XT Pro and I was wondering how I go about finding out which model packs if any are already installed in the unit? Quote Link to comment Share on other sites More sharing options...
silverhead Posted February 9, 2015 Share Posted February 9, 2015 Run Line 6 Monkey with your Pod connected. Quote Link to comment Share on other sites More sharing options...
357mag Posted February 9, 2015 Author Share Posted February 9, 2015 It says Pod Xt Pro authorized but then it spits out an error code. Do I gotta register the serial number with Line 6 before I find out anything? Quote Link to comment Share on other sites More sharing options...
357mag Posted February 9, 2015 Author Share Posted February 9, 2015 error (code 80002008) Client has been disconnected from the network. I don't see a serial number on the bottom of the unit either. I see an authorize button though. Quote Link to comment Share on other sites More sharing options...
Mr_Arkadin Posted February 10, 2015 Share Posted February 10, 2015 On a basic level (i.e. not connected to computer) when powering up you should see the model packs in the display as I recall. Also when spinning through the amps you'll see gaps in the numbering. I can't remember exactly but I think the regular amps end around 36 and start again around 102. If you have amps between those numbers you have the amp model packs. It would also be an idea to check your firmware. You need I think 3.02 to be able to use the model packs. I'll have to look up how to see the firmware version from the Pod display as I can't remember off-hand. Quote Link to comment Share on other sites More sharing options...
357mag Posted February 10, 2015 Author Share Posted February 10, 2015 It does appear that I have the model packs then. Thank You. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.