So... I got a EVH 5150 III 50w. The M13 is looking like the perfect fit (latch scene mode to change channels/effects). I have 3 questions and I know this has probably been explained over and over, but I am new to this unit.
I am looking to run it in 4 cable mode with expression 1 as a volume and expression 2 as a wah in front of the amp. Is this possible?
Is there any way to have the M13 midi control both the channel switching on the amp AND the amps effects loop (the EVH channel switch is a 4 button)? I basically want the effects loop ON at all times.
Last, if I can run it like this, is there any way to add a clean boost in there somewhere? I need to bring up the volume on channel one on the amp a bit without muddying (this amp has a shared gain & volume for channels 1 & 2, but for clean cleans there IS a volume difference between 1 & 2).
Ideally: Guitar - Volume/Wah - amp. Through the loop: noise gate for ch2&3, chorus, phaser, flanger, delay, reverb. Trails ON for delays and reverb (Think Rush Limelight end of solo into last chorus).
I'm currently using a POD XT Live with all of the modeling off, with the midi for channel switching AND using the preset volumes to control the channel volume 1/2 issue ... BUT the wah sounds like lollipop in the loop, along with the rest of the in-front effects.