Jump to content


Photo

Front Led's Not Glowing The Correct Colour?


  • Please log in to reply
2 replies to this topic

#1 gp4leigh

gp4leigh

    Just Startin'

  • Members
  • Pip
  • 7 posts

Posted 02 September 2013 - 12:17 PM

Hi, I have the l3t and the l3m. I use a normal p.a mixer (not the M20)
The front LED's are supposed to glow white. My l3t glows redish blue, and my l3m glows blue?
When I first purchased them they both glowed white, do I have a problem?
Thanks
  • 0

#2 ArneLine6

ArneLine6

    Line 6 Staff

  • Product Management
  • PipPip
  • 365 posts

Posted 02 September 2013 - 02:27 PM

Do the LEDs do that constantly? The LEDs turn red when the limiter is active (too much input) and blue when an M20d is connected. If this is a constant behavior please contact our customer service. There a few special modes you can set the LED to. Try to hold the FBS buttons while powering up. This sets the LED on/ off and could reset them.
  • 0

#3 gp4leigh

gp4leigh

    Just Startin'

  • Members
  • Pip
  • 7 posts

Posted 03 September 2013 - 03:06 PM

FBS? I assume this is feedback sensitivity button? I've tried your suggestion (Try to hold the FBS buttons while powering up) No difference, The LED stay on.


  • 0




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users