Please ensure Javascript is enabled for purposes of website accessibility Jump to content

M9 Model Select Knob No Functioning.


vfriel
 Share

Recommended Posts

Well after 3 years of faithful service I just discovered that the Model Select knob on my M( does not function properly when it's pushed.

Either I have to push it numerous times or from specific angle to get it to change an FX type. Fortunately I have already had my patches in place but this looks like a problem that is only going to get worse.

 

Anyone here experienced a similar problem?

Anyone here know of a fix?

 

Yes, I opened a ticket with Line 6.

Link to comment
Share on other sites

  • 1 month later...
  • 1 month later...

pull off knob... put a small pinch of paper towel into the knob and reinstall... Problem is that the knob can't go down far enough before it bottoms out on sheet metal cover..need to raise the knob to achieve full length of travel on pot...

 

 

This should work... just bought 2 used units having this problem...... did the above.... everything now wonderful

BEST REGARDS,

 

Jim B

Link to comment
Share on other sites

  • 7 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...