Im trying to use my old Pod xt live as an audio interface to record on Ableton Live 8. Ive got everything set up to where I get a signal on Ableton, but Im getting two output signals from my Pod to my monitors. One signal goes from the pod output straight to the monitors and the other one goes to Ableton through the usb cable and then back through the pod to the monitors. (So that if my Pod tone is clean and I have a distortion effect enabled on Ableton I hear both the clean and distorted tones at the same time) The only output cable I have is a 1/4" from the l/mono output on the pod to the monitors inputs and my Pod is connected to my pc via the usb cable. Is there any way to have only the signal from Ableton play through the monitors? I want to use effects from the pod as well as effects on ableton.