I'm using the dream rig setup with an older Variax. I have the POD 500X edit program open and I'm setting up patches.
When I edit a patch with two Amp models, I run into a problem.
I can turn off Amp B and just listen to Amp A so I can set it up the way I want it. But then if I turn off Amp A and turn on Amp B so I can edit it, I can't hear it. All I seem to hear is whatever amp model is set up in my DT25 topology. I can turn the knobs in the 500X edit program and it makes no difference - all I hear is the amp.
The only solution I've found is to turn Amp A's volume right down so all I can hear is Amp B.
Is this happening for anyone else? Any solutions?