clay-man Posted June 5, 2014 Share Posted June 5, 2014 I'm starting to have problems with my Variax. It won't work correctly unless I position the coffin to press down into the cavity and up towards the top. If I don't it will select the wrong models or plainly not turn on correctly/give a good signal. I put some card board to force it into position for now, and it's alright now, but does anyone know what could be causing this? I checked the wires that go from the coffin's case to screws and they seem ok. I tried to check other wires leading into the electronics, moving them around, but it does nothing unless I just force the coffin to lay hard on the cavity's bottom and the top side of the cavity. Help would be appreciated so I don't have to open this up again to fix the positioning (It did it again last night). I think the cardboard helps but there's a small rise in the pickguard that I find annoying and dangerous for stuff to get into the electronics. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.