Is there any fix for the Floor pod plus noise issue?floor pod plus noise delay
Posted 14 September 2014 - 11:41 AM
Posted 14 September 2014 - 12:03 PM
you don't have to break things... for them to end up broken....
quality of power, handling, environment and many other things factor in.
but if the issue didn't exist for the length of the warranty....
then the issue isn't covered as a defect anyway....
a warranty covers defects for a set length of time...
Posted 14 September 2014 - 01:46 PM
Posted 14 September 2014 - 04:33 PM
So basically it's not a quality product. Got it. I agree then, there is no fix for trashy quality.
Nope. Sometimes, with any manufacturer, a defective product gets through. That's what warranties are for.
Over the course of time however, parts can wear out or develop problems. This can happen with just about any product. In the original poster's case, because he purchased it used, there's no way of knowing whether the problem existed off the assembly line, or whether it developed later. In my opinion, Line 6 should not be responsible for a product that is now clearly out of warranty.
It sucks to have bought defective used equipment, but Line 6 cannot be responsible for a piece of gear forever.
Posted 14 September 2014 - 05:31 PM
Posted 14 September 2014 - 06:54 PM
I'm positive that there is a fix... go to the service center and have them look at it....
you're on a forum with a bunch of users not electronics repair experts.
if you want an official line6 response... call them or fill in a support ticket...
this is not the way to get that response...
your issue is really not as widespread as you'd like to believe.
and no... noone asked about warranty coverage, because everyone's unit is far past their warranty...
because their units lasted far past their warranty...
sorry none of that is what you wanted to hear....
but you will get a more official response by pursuing the correct path to get that response.
Posted 14 September 2014 - 08:11 PM
Posted 15 September 2014 - 02:47 AM
There is no one paid by line6 here.
Posted 15 September 2014 - 03:53 AM
i've noticed that the sound is present when the unit is "heated up" like 5 minutes after u got her on...
maybe a small heatsink over the U25 can solve the problem? i will try that
edit after a teardown:
the processing unit it's not so heated like i supposed, but an lm317t burns like a hell... i suppose it's 70-80°C because i can't keep my finger on longer than half second...
maybe that's the fault idk, the other lm317t aren't that warm