JDenmark Posted August 23, 2014 Share Posted August 23, 2014 I power on my Pod HD, I see the title/logo screen all nice and bright for about 5 seconds, then it gets dim for about a half a second, then bright but blank for a fraction of a second, then the process repeats. And that's all it does. Is there some sort of reset/re-boot "hold down this button while powering on the unit" procedure that will take care of this, or is my unit toast, as they say? Thanks! Quote Link to comment Share on other sites More sharing options...
zaphodboy Posted August 23, 2014 Share Posted August 23, 2014 Plug the power lead into the POD whilst holding down the left arrow navigation button. That should do the trick. Good luck! 1 Quote Link to comment Share on other sites More sharing options...
Brazzy Posted August 23, 2014 Share Posted August 23, 2014 Plug the power lead into the POD whilst holding down the left arrow navigation button. That should do the trick. Good luck! If you do the global reset (left arrow button) you'll need to recalibrate the pedal. http://line6.com/support/page/kb/_/pod/pod-hd500-hd500x/pod-hd500xhd500-pedal-calibration-r161 If the Onboard expression pedal of the POD HD500 does not sweep through parameter values as it normally would, you may need to perform a pedal calibration to reset the functionality of the expression pedal: Hold the down the RIGHT ARROW button on the 4 Way Nav Pad while powering the unit on, until you see the “Test Mode†screen (Pedal Cal, etc.), and then proceed with the steps below: If not already selected, use on the 4 Way Nav Pad to select “Pedal Cal,†as shown above. Press the VIEW button. Set the pedal to the minimum “heel†position, then press the A footswitch to set a value for the Duty Cycle. You’ll see the value set to “100.†Set the pedal to the maximum “toe†position, then press the B footswitch to set a value for the Duty Cycle. Again, you’ll see the value set to “100,†as in step 3. Press the C footswitch to prepare for automatic selection of the Scaled Pedal Value and move the pedal from min. to max. You should see the Scaled Pedal Values read “0†at the heel position and “255†and the toe position. If you get values other than 0 and 255, power off and repeat these steps, starting at step 1. Press the D footswitch to save the settings. You’ll be returned to the Test Mode screen and the Pedal Cal item will show a “P†to indicated that the pedal calibration is complete! Power your device off and back on again to start using it. ***Please Note: Re-calibration of the POD HD500's expression pedal is necessary after performing a Global Settings reset. Instructions for how to perform a Global Settings reset is available here. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.