These forums are read only, please use our new forums here.

Main :: Flextone I / II / III / Duoverb / HD147



FLEXTONE III FACTORY RESET
by guitarmagix on 2009-07-27 18:30:30

I want to perform a total factory reset of a Flextone III plus amp. I want to reset all channel memories, firmware, amp defaults and so on. How I can do that ? Thanks.



Re: FLEXTONE III FACTORY RESET
by Crusty_Old_Rocker on 2009-07-27 18:37:57

Flextone III:  hold the A and D Buttons while powering up for 8 seconds.

Cheers,

Crusty



Re: FLEXTONE III FACTORY RESET
by ricksox on 2009-07-28 11:27:21

Correct. Thanks Crusty!

Line6Miller



Re: FLEXTONE III FACTORY RESET
by guitarmagix on 2009-07-30 12:46:02

Thank you Crusty ! And many thanks to Miller too !



Re: FLEXTONE III FACTORY RESET
by griphon2 on 2009-07-31 16:43:19

I'm not sure about how to ask this. When I do this (reset), I have a dead amp (normal, no access to Line 6, if that's clear, it also appears as if the memory shorts. I can't have six bad cords... I don't...) . This is or was a pawn shop amp. I think it's memory needs to be cleared or reinstalled. I don't know how to do that. Help me, good folks...

TR~



Re: FLEXTONE III FACTORY RESET
by SteveAIT on 2013-01-29 14:54:09

I have a Fextone III here in our shop that powers up, all 4 channel switch lights, gate and comp lights stay on and the tap tempo light flashes.  After a few min the lights go on and off randomly.  I tried the rest procedure, holding down the A and D channel buttons for 8 seconds and longer while turning on the power switch and nothing changes.  Any advise??  You can email me at srrait@aol.com. Thanks!!

Steve



Re: FLEXTONE III FACTORY RESET
by spaceatl on 2013-01-29 16:22:34

I had to dig for this one...Man, this is an old thread...

You can boot the Flextone III into a safe-mode holding A on power up. Open the Monkey and flash the firmware...This doesn't really seem like a bricked amp though...Anyhoo, probably worth a shot...

http://line6.com/support/message/56846">http://line6.com/support/message/56846">http://line6.com/support/message/56846




The information above may not be current, and you should direct questions to the current forum or review the manual.