These forums are read only, please use our new forums here.
Power Adapter for the JM4
on 2010-08-18 07:40:46.3610
I have a JM4 I bought in the US.
I am now in Israel (220V), and was wondering if I can use the following power supply for use with my JM4: Output DC 12V 5A, plus on the center tip.
RE: Power Adapter for the JM4
on 2010-08-18 10:08:10.2360
JM4's do not use DC power supply units!
Our JM4's ship with the Line 6 PX2 power supply units. The specs on them are:
9V AC, 2000 mA of current, (the tip polarity is not relevant, as AC is alternating current... going +/- "alternating", etc.).
A DC power supply is not correct for the JM4.
Re: RE: Power Adapter for the JM4
on 2010-08-18 12:25:28.7150
Thank you Perry.
The reason I thought it may be compatible is because of the following:
"Note: The Stomp Box Modelers will also work under DC (Direct Current) at 12V, 500 mA minimum. The center pin is positive (yes, center pin is positive as opposed to the DC-1 power supply)."
Which appears on this page: http://line6.com/community/docs/DOC-4269
The information above may not be current, and you should direct questions to the current forum or review the manual.