These forums are read only, please use our new forums here.

Main :: Stompbox Modelers / ToneCore



DL4 power supply
by karimba45 on 2010-10-26 08:45:23

Hi all,

I have just bought a brand new DL4 delay unit to finish off my pedal board.

I have a dunlop power brick and when I went to plug the power in it wasnt compatible.

It appears the male part on the pedal is slightly bigger that the femail power brick would accept.

Stupid question, but can I try making the hole bigger on one of my adapters, or is it a totally different power requirement and hence I need to buy the power for it?

Any help greatly appreciated



RE: DL4 power supply
by Kneehow on 2010-10-26 16:34:24

Hello,

Please don't modify your existing power adapters...

The DL4 requires a power supply that can provide 9 volts of "AC" (not DC like most pedal effect power adapters!) power with at least 1500mA of current. You probably won't find too many power supplies out there that will fit the bill, so we always recommend that you stick to using the Line 6 "PX2" power adapter, as these are designed to provide the correct power voltage and current requirement our POD's and DL4's require.

Regards,

L6Perry



Re: RE: DL4 power supply
by karimba45 on 2010-10-27 08:47:24

Thank you very much for the answer!

Just very inconvenient to have to run two power supplies for one rig.......



Re: RE: DL4 power supply
by GreenAsJade on 2010-12-24 03:37:40

Googling around, people claim the DL4 can run off 9VDC as well as 9VAC.    Can this be true!?



Re: DL4 power supply
by hakvard on 2012-08-19 13:50:11

Most power bricks comes with different kinds of cables and voltage opportunities. I had the same problem as you had when my DL4 started blinking wich is a sign of low battery, but i found out that the blue cable that came with my FuelTank fitted into the DL4! What a lifesaver.




The information above may not be current, and you should direct questions to the current forum or review the manual.