These forums are read only, please use our new forums here.

Main :: POD Farm / POD Studio / TonePort



Pod farm will not read my GX drivers
by Quincygd4456 on 2011-02-23 20:15:34

The picture explains it



RE: Pod farm will not read my GX drivers
by Line6Hugo on 2011-03-09 08:47:56

Quincy,

I would recommend uninstalling all Line 6 software including drivers from your computer's control panel, then download and install the POD Farm 2.02 software which should install the latest POD Farm, Line 6 Monkey, and Drivers to your system.

Please remove all other USB devices from the computer (except for a mouse/keyboard on a desktop) while troubleshooting this issue. Completely remove ANY USB hubs, even if not in use, and test the GX on all of your computer's USB ports. Use different USB cables if you have to.

If the problem persists, I would recommend isolating the problem by testing with another computer.

If the above is fruitless, please go over the following knowledge base document:

http://line6.com/community/docs/DOC-4282

Regards,

Line6Hugo



Re: RE: Pod farm will not read my GX drivers
by Quincygd4456 on 2011-03-13 09:07:07

I Actually figured it out, I had PEAVEY ReValver software installed and it read it and when I unininstalled the software it cleared everything up!




The information above may not be current, and you should direct questions to the current forum or review the manual.