These forums are read only, please use our new forums here.

Main :: Riffworks Line 6 / Standard Edition



Is it possible to record acoustic drums with riffworks while at the same time using podfarm?
by tagus77 on 2011-07-23 06:31:42

i have a zoom r16 recorder and a set of drum mics and was hoping that i could do some drum covers. is it possible to record drums with riffworks?



Re: Is it possible to record acoustic drums with riffworks while at the same time using podfarm?
by tagus77 on 2011-07-23 06:33:47

i also have a pod ux1



Re: RE: Is it possible to record acoustic drums with riffworks while at the same time using podfarm?
by Kneehow on 2011-07-27 11:48:26

If you're using Riffworks with POD Farm, you're most likely using your UX1's instrument input and routing that through the POD Farm modelling application, then into Riffworks to record the signal.

 

Your UX1 would have to be set as the ASIO or Core Audio device in Riffworks... which means at the very most, you could plug in a signal non-phantom powered Mic into the Mic XLR jack of the UX1, create a 2nd tone (DUAL TONE) in POD Farm and then route that single mic signal (mono drums) into Riffworks.



RE: Is it possible to record acoustic drums with riffworks while at the same time using podfarm?
by Line6Don on 2011-08-01 11:56:08

Hey tagus77,

This ticket is being closed due to lack of response within 72 hours. If you still have questions or are still experiencing an issue please start a new thread and mark the discussion as a question. To do so you can follow the link below and Ask a Question:

http://line6.com/support/community/support/

For more information about using the Online Technical Support System please review our FAQ at the link below:

http://line6.com/support/docs/DOC-1451




The information above may not be current, and you should direct questions to the current forum or review the manual.