These forums are read only, please use our new forums here.
How do I assign effects to FBV Express MKII at the same volume level?
on 2011-07-23 20:49:25
I have a FBV Express MKII and a Spider IV 75. I have for switches that I assigned 4 effects. I have a clean effect(Apollo 13) in switch button A and distortion (Arachnophobia) in B. When I go between those too I have to adjust the volume for channel B. My clean is sort of high and my distortion low so when I am playing with my band I have to adjust while playing and is hard.
Also is there a cheat with that has all the effects and where are they located in the menu... sort of a diagram. I love my amp like I love my Xbox 360 and my PS3 but I am not taking full advantage of all the effects because it is pretty much try them by clicking at the amp.
I NEED HELP BAD! My first gig is this friday and having this issue resolve would make things easier for me.
Also, is any of the software use to assign the effects through the computer? I thought that was the point. I think it would be easier if I just connect the pedal to my laptop and assign the effects to the switches that way. If this is something that is available can someone tell me how to get do it?
Re: RE: How do I assign effects to FBV Express MKII at the same volume level?
on 2011-07-28 10:33:35
You might want to use our free Spider IV Edit software:
You'll primarily be balancing the Channel Volume values between patches so the overall output from patch to patch is consistent. Everything is actually stored in the amp; the FBV Express MKII doesn't save any sounds, it's just a dummy remote controller/USB interface...
Re: How do I assign effects to FBV Express MKII at the same volume level?
on 2011-07-29 06:43:11
Adjust the volume on each sound to the level you want, then save the (now new) patch. You can save to the same location (User bank/channel), rename it so you know it's been adjusted.
RE: How do I assign effects to FBV Express MKII at the same volume level?
on 2011-08-01 14:03:07
This ticket is being closed due to lack of response within 72 hours. If you still have questions or are still experiencing an issue please start a new thread and mark the discussion as a question. To do so you can follow the link below and Ask a Question:
For more information about using the Online Technical Support System please review our FAQ at the link below:
The information above may not be current, and you should direct questions to the current forum or review the manual.