These forums are read only, please use our new forums here.

Main :: Line 6 Lounge



Line 6 Spider III 2x12 150 Stereo Amp problems
by Enriquedelapaz on 2011-10-31 12:21:23

I just got a Line 6 Spider III 2x12 150 Stereo Amp. I know these amps get a bad rap, but I got a real good deal on it because it has problems.  When you turn it on it plays normally on the setting that that it is on when you turn it on.  If you leave it on that setting you can play it indefinitely. When you change the preset the little window that has the name of the preset goes blank and the amp stops making sound.  When this happens you can hear a regular clicking sound. The only way to get it to work again is to shut it off wait a few minutes and turn it back on. It always does the same thing. When you do the factory reset it works but when you change presets it cuts out again.    Anyone have any idea what the problem is and whether it is worth fixing.  This is my first post here. Thanks in advance for any help you all can give me on this problem.



Re: Line 6 Spider III 2x12 150 Stereo Amp problems
by out4adance on 2012-10-26 13:52:11

Here the problem demonstrated in a Spider III. I show which part is the root of the problem.

It's a very difficult job to replace the part itself which is only $20.

The problems is, to replace the board Line 6 wants about $160!   The problem is the Digital Signal processor.

Search for the YouTube video "Demonstration of and solution to an intermittent problem with a Line 6 Spider III amplifier"

A heat sink on the DSP does help a lot.

-Dave




The information above may not be current, and you should direct questions to the current forum or review the manual.