These forums are read only, please use our new forums here.

Main :: POD X3



Vocoder on Pod X3 Pro
by Darkoniglio on 2011-11-26 23:06:59

Hello

I've read a lot of discussion there, but I found conflicting information.

I own a Pod X3 Pro with firmware 2.10

I set an empty effect with the Vocoder on tone1

I connect a Samson condenser microphone powered by phantom power and a guitar into the instrument, both on channel 1.

Vocoder effect parameters

input 100%

mix 100%

100% decay

mix 100%

The trim of the microphone is set to max.

If I put mic1 as input, i hear the voice effected, but playing the guitar i don't hear no modulation

If Iput gtr1 as input, i hear guitar effected, but I can't hear any voice.

I already tried to reinstall the firmware.

What can I do?

thanks



Re: Vocoder on Pod X3 Pro
by silverhead on 2011-11-29 05:51:48

When using the vocoder you should not assign the mic as input to the Tone. It is automatically used/assigned when you include the vocoder FX in the guitar tone.




The information above may not be current, and you should direct questions to the current forum or review the manual.