These forums are read only, please use our new forums here.

Main :: POD X3



POD X£ Live wont connect to PC
by rovertdlobwen on 2011-11-30 13:50:39

Hi,

I just got an X3 live. Downloaded Monkey and Gearbox. Connected the x3 and downloaded all the drivers etc no problem and edited some sounds using gearbox. The next day I plugged the X3 into the computer and now it says that it cannot detect any device. Tried a different USB cable - still wont connect. Tried connecting it to my other PC - still not detected.

Any Ideas?

Is the USB on my X3 knackered?



Re: POD X£ Live wont connect to PC
by birro on 2011-12-05 04:01:49

Hey man,

At my First POD (XT Live) I had this kind of problem too.

Please check my post:

http://line6.com/support/message/334526#334526

Hope I help you with this.

Cya!




Re: POD X£ Live wont connect to PC
by Line6Hugo on 2011-12-08 16:23:24

I would recommend putting the POD X3 Live into SAFE MODE by holding the RIGHT arrow button on the face of the POD as you turn it on, then, attempt to connect to Line 6 Monkey and re-install the flash memory on the unit.  If that does not help, please make sure to do this on different computers.

If all fails, you will need to take it to an authorized service center:

http://line6.com/service_centers/">http://line6.com/service_centers/">http://line6.com/service_centers/

Regards,

Line6Hugo



RE: POD X£ Live wont connect to PC
by Line6Don on 2011-12-13 17:43:27

Hey rovertdlobwen,

Line6Hugo's answer above is correct. I have marked the answer that is correct for your question, please help out the community by marking other suggestions that were helpful to you as "Helpful Answer".

If you still have questions or are still experiencing an issue please start a new thread and mark the discussion as a question. To do so you can follow the link below and Ask a Question:

http://line6.com/support/community/support/

For more information about using the Online Technical Support System please review our FAQ at the link below:

http://line6.com/support/docs/DOC-1451

Thanks!




The information above may not be current, and you should direct questions to the current forum or review the manual.