These forums are read only, please use our new forums here.

Main :: POD 2.0, PODxt Family, Pocket POD, FloorPODs



POD XT USB problem
by ducer on 2011-12-07 01:12:50

Hi,

I bought some POD XT from a reseller and wanted to connect it to my PC. First problem which I encountered was the firmware (version 1.02) so I bought USB->MIDI cable and upgraded it to the newest version (3.01). I installed drivers downloaded using Line 6 Monkey, however the device could not be detected. I checked a firmware version and ESN and USB revisions contains zeros. Once again I flashed the device using USB->MIDI but this time in SAFE MODE, however the problem still exists.

My question is - what else I can do ? Maybe I can try with downgrading the firmware to 1.05, but I cannot find it on Line 6 website.

P.S.

Do you know official service in Poland ?

--

Kind Regards,

Wojtek



Re: POD XT USB problem
by Line6david on 2011-12-08 15:19:51

Hi,

IT the POD Xt's ESN number reads as a row of 0's this is evidence of a memory failure in the unit. You need to take the POD XT for repair:

Poland

Lauda-Audio S.C.

(macola ID: Lauda)

  1. Ul. Lesna 15 A/1

81-876 Sopot

Poland

Phone: +48 58 555 0660

Fax:        +48 58 555 0770

Contact: Marcin Popek

marcinp@lauda-audio.pl

or e-mail: www.lauda-audio.pl

Thanks,

David

Line 6 Customer Support



Re: POD XT USB problem
by RogerGLewis on 2012-02-10 09:49:02

i have the same problem if it is memory problem hoiw come the midi updating etc all goes fine using midi connectors?




The information above may not be current, and you should direct questions to the current forum or review the manual.