These forums are read only, please use our new forums here.

Main :: M5 / M9 / M13



LIne 6 M5 Model Select (button) stopped working
by bertymoe on 2011-12-21 11:03:55

Was redoing and renaming some patches..no problem....then went to get to the Set Up menu ( Hold Tap and Press Model Select)  no dice ... it went to tuner..several times,a sModel Select "press" function seems to have stopped working.

So I went to edit a patch and SAVE ( hold down Model Select) no dice.Model Select will rotate  fine ...just not the "press down" function

Tried "rebooting" the unit by unplugging /re plugging in power supply...still no...

Am I missing something? or do these switches go bad... had this unit about 2 weeks...no problems



Re: LIne 6 M5 Model Select (button) stopped working
by bertymoe on 2011-12-22 06:30:30

Fixed it....following advice on a similar thread.Pulled off knob and grabbed metal pot shaft w/pliers and lifted up. I could feel it move back into it's "seat. (like a dislocated finger going back in the socket)

Pressed down and it works.




The information above may not be current, and you should direct questions to the current forum or review the manual.