These forums are read only, please use our new forums here.

Main :: DT50/DT25



How can i let my DT 25 work and switch through midi with a voodoolab groundcontrol?
by gilvie on 2012-01-14 12:19:23

How can i let my DT 25 work and switch through midi with a voodoolab groundcontrol?

Gr. Hans



Re: How can i let my DT 25 work and switch through midi with a voodoolab groundcontrol?
by Father12 on 2012-01-15 13:24:35

Just posted same question for general MIDI. I had no response from the support of Line6.

Do you meanwhile have a solution?

Ciao, F12



Re: How can i let my DT 25 work and switch through midi with a voodoolab groundcontrol?
by Line6david on 2012-01-24 16:44:47

Hi,

From evaluating the Ground Control's manual I believe you will have to use the Instant Access feature in the Ground Control to assign the Proper MIDI CC values to footswitches 1-8 on the ground control. The MIDI Implementation guide for the DT50 is listed in your Pilot's Guide on the last page.

http://line6.com/data/6/0a060b316ac34f059348b7e6f/application/pdf/DT50%20Quick%20Start%20Guide%20-%20English%20%28%20Rev%20C%20%29.pdf">http://line6.com/data/6/0a060b316ac34f059348b7e6f/application/pdf/DT50%20Quick%20Start%20Guide%20-%20English%20%28%20Rev%20C%20%29.pdf">http://line6.com/data/6/0a060b316ac34f059348b7e6f/application/pdf/DT50%20Quick%20Start%20Guide%20-%20English%20%28%20Rev%20C%20%29.pdf

I would suggest you contact Voodoo Lab about setting up the pedal:

http://www.voodoolab.com/contact.htm">http://www.voodoolab.com/contact.htm">http://www.voodoolab.com/contact.htm

Or reffer to the manual for your Ground Control:

http://www.voodoolab.com/manuals/gc_origv2manual.pdf">http://www.voodoolab.com/manuals/gc_origv2manual.pdf">http://www.voodoolab.com/manuals/gc_origv2manual.pdf

Thanks,

David

Line 6 Customer Support



Re: How can i let my DT 25 work and switch through midi with a voodoolab groundcontrol?
by Line6Hugo on 2012-02-02 14:08:24

Father12,

The MIDI Implementation for the DT25 has not yet been documented on our site, so at this time, controlling the amp via MIDI is not fully supported.  We will be relelasing this data when it becomes available.

Regards,

Line6Hugo



Re: How can i let my DT 25 work and switch through midi with a voodoolab groundcontrol?
by daniderock on 2012-07-15 04:07:21

Hi. Do you already have the fully MIDI implementation to the DT25?

I am trying to change the Drive Knob via MIDI CC, but...

even assigning the CC#13 and some values between 0-127 I can not be able to sucess.

Do you have some clue about this fact?!

Thank you

Cheers from Brasil




The information above may not be current, and you should direct questions to the current forum or review the manual.