These forums are read only, please use our new forums here.

Main :: POD Farm / POD Studio / TonePort



Help with cubase and ux2!
by sagejudd on 2012-01-25 19:50:39

When I use podfarm I can hear my guitar fine. But when I go to cubase and try to set my ux2 as my driver it doesn't show up. I've tried reinstalling the drivers, but it still doesn't show up. It's very frustrating.



Re: Help with cubase and ux2!
by sagejudd on 2012-01-26 14:24:10

am i going to get any help?



Re: Help with cubase and ux2!
by BigChas52 on 2012-01-26 14:42:40

Check to make sure that you are looking for the UX2 as an ASIO input device.



Re: Help with cubase and ux2!
by BigChas52 on 2012-01-26 14:47:11

Also, check out this manual which has good info on using your UX2 in Cubase.  http://line6.com/data/6/0a060b316ac34f0593ccf3e0a/application/pdf/POD%20Farm%202%20Recording%20Setup%20Guide%20%20-%20English%20(%20Rev%20A%20).pdf

Usually you can find what you are looking for on this site in the "Manuals" section (under Support).  There are lots of treasures there.

Safe travels.



Re: Help with cubase and ux2!
by sagejudd on 2012-01-26 18:36:39

thanks a bunch! i looked through there previously and skipped over an important part. i needed to go to control panel and set up some stuff there.




The information above may not be current, and you should direct questions to the current forum or review the manual.