These forums are read only, please use our new forums here.

Main :: POD HD


Support forums for all POD HD products


Why HD 300 sound change doesn't work properly?
by bar-fred on 2012-03-19 04:19:49

Hi,

why is it not possible to switch from one sound to the next without an interruption of the sounds? It always seems to change to some preset and changes than to the next tone. I've got a HD300 and work with a MacBook Air.

Thanks for any help

Bar-Fred



Re: Why HD 300 sound change doesn't work properly?
by silverhead on 2012-03-19 05:36:46

There is some delay because you are connected to your computer and using the Editor. Tis requires a data transfer to keep the two memory banks (HD300 and computer) in sync.

Disconnect the HD300 from your computer and the delay will disappear.



Re: Why HD 300 sound change doesn't work properly?
by Line6david on 2012-03-19 16:05:27

+1 to silverhead,

When connected to a computer the data transfer rate will sloww the unit switching between patches. This is normal. When you use the 300 as a standalone device this should disappear.

Thanks,

David



Re: Why HD 300 sound change doesn't work properly?
by bar-fred on 2012-03-19 23:27:53

:-((

since I usually play to songs from my computer I need it to be connected, is it enough to close the editor?



Re: Why HD 300 sound change doesn't work properly?
by silverhead on 2012-03-20 06:52:07

Yes - simply closing the editor should eliminate the delay.




The information above may not be current, and you should direct questions to the current forum or review the manual.