These forums are read only, please use our new forums here.

Main :: Stompbox Modelers / ToneCore



DL4 resistor question! Urgent help needed...
by Danndubblewe on 2012-05-14 10:51:16

My buddy has had a DL4 for nearly 8 years and his switches finally bit the dust. In a late night modding session I accidentally sliced off R29. I simply am requesting the value of that single resistor so that I can get his beloved DL4 back up and running. The mod went without issue - just switch 1 (far left) will not activate due to my incompetence.  We spent over a hour on his garage floor searching for the tiny component to no avail.

For the love of god...please help!  Would it be OK to use a "regular" 1/4 Watt through hole resistor gently soldered to the two top points or is a SMT resistor absolutely necessary?  I would assume it wouldn't matter because they're all resistors, right?

Thank you SSSOOOO much for any help given.



Re: DL4 resistor question! Urgent help needed...
by Danndubblewe on 2012-05-14 14:00:08

Even just the code on the top of the resistor would work.  Literally, anything! 



Re: DL4 resistor question! Urgent help needed...
by Danndubblewe on 2012-05-15 00:00:53

The value code was 1001 or 1K!  Thanks all!




The information above may not be current, and you should direct questions to the current forum or review the manual.