These forums are read only, please use our new forums here.

Main :: POD HD


Support forums for all POD HD products


how can i do w/d/w recordings with the hd 500?
by alexisltd on 2012-08-03 06:01:14.6070

My idea is to record stereo effects and amp clean signal separately to allow better control in the mix


is this possible? maybe using the output S/PDIF for the dry signal and the analog outputs for the stereo wet effects?



Re: how can i do w/d/w recordings with the hd 500?
by meambobbo on 2012-08-03 11:21:16.6650

I would use the SPDIF out for wet, and record dry via the FX loop out.  The FX loop send is actually a 3-pin so it sends stereo, so you could have left/right wet AND left/right dry.

Place the FX Loop before the "wet" effects and set its Mix parameter to 0%.  Then it's just sending the signal, not receiving anything back into the Pod's signal.  It's basically a Y cable in your chain.  The wet effects are then processed and sent out via SPDIF.

http://foobazaar.com/podhd/toneGuide/odds#wetDry">http://foobazaar.com/podhd/toneGuide/odds#wetDry">http://foobazaar.com/podhd/toneGuide/odds#wetDry



Re: how can i do w/d/w recordings with the hd 500?
by alexisltd on 2012-08-03 18:51:54.9440

very good idea!! thanks for your reply....very much appreciated!!!



Re: how can i do w/d/w recordings with the hd 500?
by meambobbo on 2012-08-05 19:25:11.5960

I've never actually run it this way personally and I'm not sure how many other people have as well. So be sure to let us know how it works out



Re: how can i do w/d/w recordings with the hd 500?
by alexisltd on 2012-08-05 23:08:20.3140

works perfectly!




The information above may not be current, and you should direct questions to the current forum or review the manual.