These forums are read only, please use our new forums here.
on 2012-08-14 06:45:03
I have a mixer connected to the line inputs on the back of the UX2. The mixer has 2 instrument and mic inputs that can be recorded by selecting line 1 & 2 in gearbox and they record in stereo. However, I have my microkorg connected the left and right line inputs on my mixer and I cannot record by selecting line 1 & 2 in gearbox, I need to change it to line 2 only and the volume on my mixer shows that only one channel has volume, even though it plays back through both channels. If I connect my microkorg direct to the line inputs in the back of the toneport instead of the mixer, I can record once again by selecting line 1 & 2 in gearbox.
Therefore, I'd like to know if there is a reason why this happens as it means I cannot use the mixer to play guitar and microkorg at the same time.
Any help would be most appreciated!
Re: Recording Help
on 2012-08-14 07:12:28
Sorry folks, it was a dead cable!!
The information above may not be current, and you should direct questions to the current forum or review the manual.