These forums are read only, please use our new forums here.
on 2012-09-02 06:47:03
This has never happened to my AX2 212. When the power is on the display says err and the amp makes a light popping sound. Any suggestions? It seems to be stuck in a loop. The display goes through a series of presets and scambled numbers over and over.
on 2012-09-02 08:58:02
First try a hard reset. You lose all of you presets - but this is the first thing you should always try when these amps go screwy. And you should be bakcing your stuff up using midi anyway. If that doesn't work - then It needs to be serviced. Take to a Line 6 service center. I had one do this that was unrepairable according to the service center. They didn't charge me and they pretty much tried everything. I have it in my garage fo parts in case my other AX212 goes bad. Good Luck.
The information above may not be current, and you should direct questions to the current forum or review the manual.