These forums are read only, please use our new forums here.

Main :: POD Farm / POD Studio / TonePort



No input signal in POD Farm 2.5
by TylerSocholotuik on 2012-09-14 19:00:07

I tried to use my UX1 after not touching it for a week, and there is no input signal. I checked the license manager for authorization, checked drivers, checked cables, checked everything, and there is simply no signal. It worked fine before, and I don't beleive any damage could have occured in a week of sitting. I would greatly appreciate some suggested solutions! Thanks.



Re: No input signal in POD Farm 2.5
by TheRealZap on 2012-09-14 19:07:01

check the line6 control panel icon, the inputs may have changed.



Re: No input signal in POD Farm 2.5
by TylerSocholotuik on 2012-09-14 19:18:52

I made a stupid mistake. It turns out that both of the cables I tried were bad. I plugged them into my amp and neither of them worked. I'm not sure how two cables crapped out all of a sudden, but it happens. Thanks for the answer anways.




The information above may not be current, and you should direct questions to the current forum or review the manual.