These forums are read only, please use our new forums here.

Main :: M5 / M9 / M13



M9 suitable for use with H&K Switchblade?
by BadHorsie01 on 2012-10-15 07:40:50

Hi guys, hope you can help.

I've seen sort of similar to what I need on this discussion, http://line6.com/support/thread/86707 , but am not fully grasping whether I'd be able to use the m9 to change the channels on my SwitchBlade at the same time as changing effects? Would I be able to go to specific channel "banks" and "patches" in the banks on my amp and assign, say, Harmoniser, delay and flanger? I'd be going straight in the front end of the amp.

So it'd look a little like this:

Bank1:

Patch A: Clean(amp), Compressor, Chorus

Patch B: Dirt(amp), Reverb, delay, harmoniser

Patch C: Dirt(amp), Delay, Octave

Patch D: Dirt Lead(amp) Delay, Phaser, Harmoniser

Bank2:

Patch A: Clean(amp), Compressor, Reverse Delay

Patch B: Dirt(amp), Reverb, delay, Flanger

Patch C: Dirt(amp), Delay, Whammy

Patch D: Dirt Lead(amp) Delay, Phaser, Harmoniser

Sorry if the questions have been asked and answered. I can't find them and I'm also not too bright when it comes to midi.

I know I've used my X3 Live to do this before but it was a little tone sucky so I stopped using it. I thought I'd ask for the benefit of the Line6 community knowledge before I purchase the unit

Best wishes and thanks in advance for any help,

Mick



Re: M9 suitable for use with H&K Switchblade?
by danidelarosa on 2012-10-15 10:40:37

It should definitely be possible. I use an M13 to switch channels on my Tubemeister 36, which only has a MIDI in and it works flawlessly. The tone sucking thing in my experience might be due to 4-cable method being plugged the wrong way. Check out the instructions on the M9, they probably specify how to achieve it.

Good luck!



Re: M9 suitable for use with H&K Switchblade?
by BadHorsie01 on 2012-10-15 12:01:03

Hi danidelarosa, thanks for the reply!

The tone suck was with an X3Live. I don't have the M9 yet. This was an exploratory discussion to see if it's able to do what I want



Re: M9 suitable for use with H&K Switchblade?
by leejlewis on 2013-04-08 13:08:56

Hi i have a H&K Tri Amp with the midi board added. Can you explain how to set up the M13 to control the channels on the amp

Thanks

Lee



Re: M9 suitable for use with H&K Switchblade?
by leejlewis on 2013-04-08 13:09:17

Hi i have a H&K Tri Amp with the midi board added. Can you explain how to set up the M13 to control the channels on the amp

Thanks

Lee




The information above may not be current, and you should direct questions to the current forum or review the manual.