These forums are read only, please use our new forums here.

Main :: M5 / M9 / M13



Quick questions about M13 Fx loop
by drunkjoe on 2012-11-10 16:48:58

Hi guys, I have a question about the FX loop.

A) If I want to use the M13 just for modulation effects and use my amp's distortion, what would be right way to connect it and which is the correct setting in the menu? Post all?

B) If I hook the M13 using the 4cm on my head and want to use FX1 and FX2 on front of the amp and FX3 and 4 on the FX loop, the correct setting in the menu would be post FX2?

Thanks!



Re: Quick questions about M13 Fx loop
by phil_m on 2012-11-11 10:58:39

A) If you want all of your modulation effects after your amp's distortion, you could simply put the M13 entirely in your amp's loop. So just run a cable from your amp's effects send to the M13's in, and then another cable from the M13's out to your amp's effects return.

B) Yep, you have it correct.



Re: Quick questions about M13 Fx loop
by drunkjoe on 2012-11-11 11:23:32

Thanks for the quick response Phil.

BTW, if I'm only using the loop I must put "pre all" or "off" in the settings menu?

Thanks



Re: Quick questions about M13 Fx loop
by phil_m on 2012-11-11 14:20:10

If you don't have anything connected to the M13 effects loop jack, it doesn't matter what you have those settings set to. The loop will simply be out of the signal chain.



Re: Quick questions about M13 Fx loop
by drunkjoe on 2012-11-11 16:40:54

Got it! Thanks!




The information above may not be current, and you should direct questions to the current forum or review the manual.