These forums are read only, please use our new forums here.
on 2012-11-14 14:21:51
I just got a POD X3 that I want to plug into my Fender Blues Deluxe Reissue. Whenever I plug my POD in the amp I get quite a good level of noise that I don't get when I plug my guitar straight into the amp. The noise persists as long as the POD is on. I tried to select the combo output but the noise is still there.
Are there any known fixes for this issue?
Thanks a lot
on 2012-11-14 14:30:26
Sometimes the usb connection can introduce noise. Does the noise disappear when the X3 is disconnected from your computer?
Also, make sure the X3 Master Volume is at a high level - this provides the best signal-to-noise ratio in the output.
on 2012-11-21 07:51:28
Is there a lot of noise even if you have no guitar cable plugged into the input the POD?
Are you using hi-gain patches? This will usually introduce noise. If so try putting a noise gate.
The information above may not be current, and you should direct questions to the current forum or review the manual.